My shopping cart
Your cart is currently empty.Continue Shopping
Figuring out your ring size or necklace length while at home from COVID can be difficult, but not impossible! And never fear, DMG Designs rings have 1 free sizing or exchange, so it's okay if it's not perfect. My rings are measured using the US Ring sizing system, if you know your size in another country, use my international sizing chart below. Or you can use one (or all) of the methods below to figure out your size.
Before you begin taking your measurements, pick the finger on which you want to wear your ring. The fingers on your dominant hand tend to be larger than those on your non-dominant hand, so keep that in mind when measuring for your ring size.
Ensure that your finger is at its normal size before taking a measurement. Cold weather can cause your fingers to shrink a bit, while heat or water retention caused by food, medications, or illness can cause finger swelling.
You can measure your ring size using either string or ribbon. Take one of these and wrap it around the base of your finger, marking where the string or floss overlaps with a pen. Then, line that up with a ruler and take down its length and use the chart below to find your US Ring Size. Make sure to not pull the string too tight, as it should be a comfortable fit.
Use the printable guide to cut out and measure your finger use the slide tool, or measure and existing ring use the hole cutouts. Just be sure to click the link and print sized at exactly 100% to ensure proper size.
Most DMG Designs necklaces automatically come with an 18" sterling silver chain as this is the most popular and versatile necklace length; but can be shortened or lengthened by request. Check out these charts to decide if you want a longer or shorter length.
Women's Necklace Length
Fits most people like a choker.
Falls around the base of the neck like a collar. On a petite woman it will hit your collarbone, on plus size women it would be close to a choker.
A common choice for women that will fall just below the throat at the collarbone. The is the standard DMG Length
Will fall a few inches below the collarbone and allow a little more breathing room. Perfect for a low, plunging neckline of wearing over a turtleneck.
Falls at or above a low neckline.
Falls below any neckline.
Will hang below bosom.
Men's Necklace Length
Falls just around the base of the neck.
A common length for men which falls right at the collarbone.
Falls a few inches below collar bone and can be worn over or under a shirt.
Extra long mens length, falls just above the sternum.